super laycryl is a highly flexible liquid applied emulsion reinforced with abe®membrane to provide an in situ, seamless professional waterproofing system.
Professional Liquid Waterproofing Compound.
super laycryl is recommended for:
- All types of flashings.
- Parapet walls.
- Flat roof waterproofing.
- Re-waterproofing over existing waterproofing systems.
- Sealing of joints, laps and roofing screws on corrugated roofs.
- The system is for non-trafficable roofs.
Advantages
- super laycryl is an all-in-one system.
- There is no need for separate primers (apart from metal surfaces) or top coats.
- It has excellent weathering properties, adhesion and is tough, flexible and non-toxic.
- It comes in a wide range of colours.
- 10-year conditional product warrantee.
Surface Preparation
All surfaces to be clean, dry, sound and free of all laitance, grease, oil or loose and flaking particles.
Bonding / Priming
All surfaces (except metal) – Mix 1 part super laycryl with 1 part clean water and prime total area to be covered. As a guide, 0,1 litre of super laycryl mixed with 0,1 litre of water will prime an area of 0,75 m2.
Allow to dry for ± 30 minutes.
Metal surfaces only – Prime with 4 metal primer.
This not only gives excellent adhesion but resists rust. Allow to dry for 4 hours.
NOTE:
Do not use solvent based bituminous solutions as a primer.
Coverage
2,1 L/m2 for total system.
Application
First coat (all surfaces after priming) – Brush or roll on a fairly thick coat of super laycryl (1 litre/m2). Bed the membrane into the wet coat by using a roller or a stiff brush, avoiding the formation of bubbles or wrinkles. On flat surfaces it is recommended to use a fluted aluminium roller. Membrane overlaps should be a minimum of 100 mm on end laps and 75 mm on side laps.
Second coat – Once the first coat has dried sufficiently to take working traffic (2 – 3 hours depending upon weather), apply a second coat of super laycryl (0,5 litre/m2) to ensure the membrane is completely saturated.
Third and final coat – When the second coat is dry, apply a finishing coat of super laycryl at right angles to the second coat (0,5litre/m2).
Protection on Completion
Whilst super laycryl is designed for an extended life, it is important to apply a maintenance coat (super laycryl) every 2 to 3 years to validate the product warrantee
Note: Do not cover with stones or stone chippings
Model Specification
Coloured acrylic and rubberised bitumen waterproofing flashing system plus abe® membrane.
The waterproofing/flashing system will be super laycryl, a single-pack, elastic acrylic and rubberised bitumen compound applied in accordance with the recommendations of a.b.e.® Construction Chemicals, including abe® membrane and 4 metal primer where necessary.
Packaging
1L, 5L, 20L containers.
5L kits (liquid & membrane).
Important Note
This data sheet is issued as a guide to the use of the product(s) concerned. Whilst a.b.e.® Construction Chemicals endeavours to ensure that any advice, recommendation, specification or information is accurate and correct, the company cannot – because a.b.e.® Construction Chemicals has no direct or continuous control over where and how a.b.e.® Construction Chemicals’ products are applied – accept any liability either directly or indirectly arising from the use of a.b.e.® Construction Chemicals’ products, whether or not in accordance with any advice, specification, recommendation or information given by the company.