abe Bond Plasta Enhancer
Acrylic Plaster Primer & Mortar Enhancer
Description
abe.®bond plasta enhancer is an aqueous dispersion of fine acrylic copolymer particles.
Uses
abe.®bond plasta enhancer is very stable in an alkaline environment and perfectly compatible with hydraulic cements. abe.®bond plasta enhancer is recommended for the following applications:
Primer coat for renderings and toppings. Cement rendering sand mixed type renderings. Base coat, waterproofing coat for plaster and floor finishes. Cement toppings not manually compacted. Primer for floor repairs and self leveling screeds. Additive for cement grouts used to waterproof surfaces.
Primer for render coats applied to abe® dura.®flex.
As a general Mortar and screed cohesion enhancer.
Toppings containing special aggregates and cement (designed to resist wear and tear, dust proof).
Mortars used to finish and re-profile corners and external trim. Bonding mortars for construction joints.
Jointing mortars for masonry. Also used to bond traffic islands and sidewalk curbing to concrete or asphalt. Jointing and caulking mortars for masonry joints, chimney stacks, mortar fillets etc.
abe.®bond plasta enhancer increases mortar plasticity, cohesion and adherence. Furthermore, it improves tensile strength, abrasion resistance and impact strength. As this product is not affected by hydrolysis, it is ideal for surfaces in contact (permanent or occasional) with water including salt water.
abe.®bond plasta enhancer decreases the modulus of elasticity, eliminates hairline cracking and reduces shrinkage and dust, accumulation. It improves mortar water-tightness and resistance to grease, fuel oil and weak acids. Mortars containing abe.®bond plasta enhancer are non-toxic and may be placed in contact with food products and drinking water.
Advantages
· Ready for use.
· Improves non-structural bond of cement screeds, renders and gypsum plasters.
· Bonds to sound PVA/acrylic surfaces.
· Good spread rate.
· Economical.
· Easy to apply.
Typical Physical Properties
Density: 1.01 g/cm3
Colour
Milky White
Surface Preparation
· All surfaces should be clean and sound.
· Remove all surface grout, unsound concrete and loose material.
· Remove any traces of grease.
· Saturate surface with water then mop up excess. When abe.®bond plasta enhancer is applied, the temperature of surfaces will always be above 5 °C.
Mixing
abe.®bond plasta enhancer must not be diluted.
abe.®bond plasta enhancer, must be mixed well before used.
Coverage
Approximately 10 m²/L
Application
abe.®bond plasta enhancer must not be diluted and should be used directly from can. Applied by brush, roller or sprayed on. Coating should not be allowed to dry before placement of toppings and coatings.
Avoid ponding of abe.®bond plasta enhancer, if required spread evenly with stiff brush.
Cleaning of Equipment
Tools, brushes and mixing equipment should be cleaned immediately after use and before material has set with abe® super brush cleaner followed by washing with soap and water.
Protection / Maintenance on Completion
The newly applied mortar/screed or plaster must be kept damp for at least fi ve days to promote good curing.
Handling & Storage
abe.®bond plasta enhancer has a shelf life of 12 months if kept in a dry cool place in the original packaging. In more extreme conditions this period might be shortened.
Health & Safety
Product safety information required for safe use is not included. Before handling, read product and safety data sheets and container labels for safe use, physical and health hazard information. The safety data sheet is available from your local a.b.e.® Construction Chemicals sales representative.